Dimple die

Construction Zone

$Don\$

AutoShrine · Vive le Prole-le-Ralliat · Donate | Twitter · Facebook

Forum List Topic List Start New Topic

Page 2 of 2 Pages:

Newer Topic Older Topic

alosix
Jason Powers
Elite Moderator
Location: Lyons, CO
Join Date: 08/02/2011
Age: Midlife Crisis
Posts: 326

Rally Car:
02 WRX, still to quiet, but it finished a rally

alosix

Re: Dimple die
February 29, 2012 10:09AM

Registered: 08/02/2011
Posts: 326

Quote
Doivi Clarkinen

Quote
Andrew_Frick
Dave what did you use to cut the holes? Was it just a hole saw?

Unibit.

Would much rather use one of those on sheet than a hole saw. I'll probably be making holes on the torchmate table/rotary punch (only up to 1" I believe).

My question would be.. what sizes would be useful?

Quote

This isn't floor mat anarchy

Please Login or Register to post a reply

Gravel Spray
-------------------------------------------------
Infallible Moderator
Location: ------------------------------------------------
Join Date: 07/25/2008
Posts: 157

Rally Car:
-------------------------

Gravel Spray

Re: Dimple die
February 29, 2012 12:42PM

Registered: 07/25/2008
Posts: 157

Quote
Doivi Clarkinen
I'm a cheap bastard when it comes to tools sometimes.

Made with a 12mm 1/2" drive socket and a piece of roll bar tubing in the vice. Also, a hammer was involved.

damn...the stepped socket is a good idea. I've been using a ballpeen hammer and a short section of tube in the press.

Please Login or Register to post a reply

Page 2 of 2 Pages: